Work Gallery

416ci build underway. This Whipple equipped LS3 came to us with drivability issues. Found misfire counters turned off in the tune, narrowed down to a heavy misfire on cyl 5. Upon tear down found lifter and lifter bore damage, sent block out to get machined and while we had it there, got some extra displacement out of it. Now time to assemble, and get it into the next step of completion!

GT350 came in with no ac, dealer had recently "allegedly" replaced the compressor, our findings were different. Seems they only replaced the clutch and the clutch had overheated and broken off. We replaced the whole AC compressor with an OEM one and double checked the circuit and he was good to go.  

416ci going into this SS being topped with a Whipple, follow us for more build progress.  

442ci motor assembled and ready to drop in! Goal is first fire up on Friday then perform our quality control checks.  

GXP in for a misfire, found a lifter had gotten chewed up but luckily the cam lobe was undamaged, slapped a new set of lifters and gaskets and back out on the road it went! 

Buttoning up this engine/trans swap from customers previous vehicle into his current vehicle. Installed a fuel setup to run E85 and remove the meth injection. Few more finishing touches and it should be ready for first fire up and address any issues before being sent off to the dyno. Killer job by Kyle over at Chesapeake Automotive Concepts for machining the blower snout to fit a 103MM TB to this Magnuson along with other components that required fabrication